Mounting Frame (ALR601)
Constructed of 22ga galvanized steel for optimum rigidity. The frame includes a mounting ring that accommodates up to 5/8” (16mm) ceiling thickness. Dimpled spring clips for firmly holding reflector in place without damaging the surface of the reflector. Hanger bars installed on short side.
Mounting Frame (ALR602, ALR606)
Includes 20ga cold-rolled steel mounting ring with 15/8" (41mm) deep collar for various ceiling thicknesses. Reflector firmly held in place with dimpled spring clips. Hanger bars installed on short side.
Listed for through branch circuit wiring. Maximum eight no. 12 AWG 90°C branch-circuit conductions (four in and four out). Ten 1/2” knockouts with true pry-out slots and eight knockouts with Romex® cable clamp. Ground wire is provided on J-Box.
Hanger Bars (ALR601)
Rigid hanger bars extend up to 25" (635mm). Score lines on the hanger bars allow for tool-less shortening down to 12" (305mm). Built-in line-up foot allows for accurate housing height during installation. Integrated T-bar clips easily snap onto T-bars.
Hanger Bars (ALR606)
Architectural frame brackets accepts C-channel and EMT conduit. Vertically adjustable.
Integral thermal protector (RP1B thermal coupler, will disconnect if insulation is detected), attached to the junction box
The enclosed quick disconnect allows for easy installation of the LED engine and reflector.
Diffuse lens mask the LED from direct view
Constructed of spun aluminum that provides optimal distribution of light with low glare.
Available with high powered 12W, 15.5W, 23W, 31.1W or 49.1W CREE® LED chip that maintains uniform intensity with a maximum luminous flux of 890, 910, 1348, 1700 and 2848 respectively; with a typical 85 CRI and a 35,000 hour life span. Available in 2700 K, 3000 K, 3500 K and 4000 K nominal color temperature.
This fixture is dimmable when used with 0-10V for 12-49.1W at 120V (Consult factory for compatible dimmers).
Constructed of extruded aluminum designed to facilitate heat dissipation and reduce LED junction temperature.
Mounted on the junction box to allow for easy maintenance, the LED driver features a power factor larger than 0.9, and THD of less than 30%. Provided with an integral thermal protection to sense over temperature or internal failure. 120V, 60Hz.
LED Driver Upgrade Options
2-Wire Lutron®: Compatible with forward phase control technology, for use with Lutron forward phase controls (neutral wire required). 120V only, 50/60Hz, 40W max. 3-wire Lutron®: Compatible with standard 3 wire line voltage phase control technology for consistent dimming performance and compatibility with all Lutron 3 wire fluorescent controls. Suitable for integration into a planned or existing EcoSystem lighting control solution. 120V, 50/60Hz, 40W max
Suitable for use in damp locations.